How I made this Automatic Door using #arduino and IR sensor?

У вашего броузера проблема в совместимости с HTML5

Steps to make this Automatic door opener:

1. Place the Arduino Nano and the IR sensor on the breadboard
2. Connect the GND and VCC pin of the IR sensor to the GND and +5V of the Arduino nano
3. Connect the output pin of the IR sensor to Digital pin 2 of Arduino nano
4. Connect the servo motor to the digital pin 3 of Arduino nano and connect Vcc and Gnd of the servo motor to Vin and GND of arduino nano
5. Upload the code

#shortsvideo #shortsvideo @Arduino